I see you have a lot of comments on your sticky situation. I had a lot of fun getting my corn off this year because of the mud. My combine has a mud hog and I was still having problems getting stuck. We do what we have to do and no one should be faulted for trying. Your combine is newer that mine so I know it has a place to hook on the rear to help get unstuck.
I will give you some advice about combining in the mud.
First go as fast as you can and still harvest your crop even if this means not taking in a full width cut. When the machine begins to lose traction stop right then. Do not try to get out without help. Spinning the wheels and digging yourself in will just make it tougher to get out. When the pulling tractor is ready to pull you out put your combine in the same gear that you would be using while combining but of course in reverse. Slow down the engine RPMs if you can and time the combines attempt to get out with the pulling tractor. In other word start together. Be sure you have someone watch and guide you so that you don't back into the pulling tractor. Cross your fingers and pray...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
