Posted by Eldon (WA) on January 31, 2014 at 23:02:18 from (98.225.11.231):
In Reply to: Wet Sleeves posted by Jenny Lindsey on January 31, 2014 at 22:29:46:
Quoting Removed, click Modern View to see
I've done them a number of ways. If you have the engine apart and the crankshaft out you can drive them out with a hammer and a block of hard wood from the bottom. Turn the block over and set it on a couple of 4x4 blocks if you can.
You can also use a long piece of 3/4" threaded rod with a block on the bottom and a block bridged on the top and draw it up and out with a nut on the top (I would use this method if I was going to re-use the sleeves),
I would also think that you could use a piece of chain and drop it thru and wrap it around a block at the bottom and a long heavy pipe up above with a 4x4 as a fulcrum and basically use it like a big lever to pop them out. (I haven't tried this way yet).
They should come out fairly easy once they are flush with the bottom web as the O-rings will be out of the bore. Good luck!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
