Posted by JD Seller on February 03, 2014 at 21:36:25 from (208.126.196.144):
In Reply to: portable hog house posted by Al Baker on February 03, 2014 at 18:45:49:
The ones we used to use where a an elevated slat floor type. You has a 10 x 20 floor half and a 10 x 20 shed half. The floors where just 10 foot oak 2x4s nailed to 3x12 runners on edge. When you had the two halves together you had a 20 x 20 pen with slats under all of it. I usually set the 3x12s up on a 8 inch concrete block. You could put 40 feeder pigs in one of them and finish them to market size without moving the floors. They worked real well.
After each batch we just pulled them ahead and hauled the manure out to the fields. When it was cold we would stand straw bales up around the bottom of the floors this kept the drafts off the hogs in the shed half.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
