Posted by Donald Lehman on February 14, 2014 at 08:04:36 from (50.122.167.210):
In Reply to: OT Identifiy firewood posted by kickinbull on February 13, 2014 at 12:03:02:
Elm.
When I was a kid we didn't have a wood splitter. We used to rip the stuff about 3/4 of the way through with a chain saw and the stuff barely split then. Used to saw it through with an old Muck-a-luc 325 gear drive. That was almost as bad as splitting it with wedges. Pop never really apperciated my sugestion that we bore a hole in the blocks and use dynamite to split em. Some people have no sense of humor. Sure wish I had my 385 Husky back then! And you are right. The darned stuff doesn't even split that good with a wood splitter. Decent fire wood if it's dry though.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
