Posted by Dieselcowboy on February 17, 2014 at 10:26:25 from (108.79.210.46):
In Reply to: Re: 6v to 12v posted by David G on February 17, 2014 at 09:56:35:
andy r : This has been what I do when I make the changes. - replace battey - neg. ground - 12v coil with internal resistor - 12v regulator as close to identical to the old one as possible. - 12 light bulbs - change wires from side to side on back of amp gauge if it was a positive ground sys. before you started. I have run this way on my tractors for quite a few years. But they do not parade around. I use these as they were intended in a hay operation. Have not so much as had to charge a battery once since I converted. To me it's nice to leave to original look and fit of the original gen and have the convince of 12v. The purpose of the post was to call out the nonfactual part of the "6v cannot be converted to 12v" because it can and work just fine.
This was just a tip to help those who do like the original look and want to use this direction.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The River Tractor - by Charlie English Jr.. This is a 4010 John Deere that was used to farm on the Diamond Island which is in the Ohio River about 15 miles southwest of Evansville, Indiana. About ten years ago, this tractor was parked close to the bank as the river was washing the bank of the island away.
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
