Posted by Hal/ Eastern WA on February 24, 2014 at 13:35:01 from (97.114.109.222):
In Reply to: Furnace Ignitor posted by El Toro on February 24, 2014 at 06:57:09:
I just had to replace the ignitor in my Rheem natural gas furnace last week. I believe the original one lasted more than 17 years.
The replacement part looks like the one in your photo, but mine cost me $50. It was fairly easy to replace and since the old one quit getting red hot, the problem was pretty easy to diagnose. When I checked the old part with my meter, it showed open.
It looks like the element on the new part is about half as thick as the old one was. I wonder if I will get anywhere near 17 years of use out of the replacement part? I bought a second one for a spare to keep on hand.
For the last year or so, my furnace would sometimes not stay lit on the first try, and the ignitor system would cycle again, sometimes 3 times until it would stay lit. I read in the manual that came with the furnace that the flame sensor should be cleaned with steel wool if the ignitor system cycles like that. So I figured out what the flame sensor must be and carefully cleaned it with fine steel wool. Since that time, the furnace has lit properly every time I watched it. I wonder if the failure of the original ignitor might have been at least partly caused by the dirty flame sensor causing the ignitor element to cycle so often.
If I have any more trouble with the furnace not staying lit like that, I will replace the flame sensor.
Other than changing filters, I have never worked on that furnace before. It has always worked just fine for me. Real glad I could fix it myself!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.