If everyone is having the same maintenance problem its a bad design = design defect.
Changing spark plugs isn't difficult and shouldn't be -- except in a ford.
By the way if you follow the Ford procedure their is still a very high probability that you'll end up with the stripped plug blow out problem. And ford recommends a head replacement - and a number of dealers recommend a new motor as the cost of the head replacement is high
The problem is that they didn't leave sufficient metal / or use a stronger alloy in the heads where the spark plug threads are. When you remove the plug you end up tearing out some of the surrounding metal. The new plug goes in without sufficient good threads to hold it in and it blows out.
Again design defect
just because you were the exception and had good luck doesn't diminish the problem
If it was simply some one over tightening the plug until it gets easy then I'd agree with you.
But from everything I've heard it's more than likely the removal that's causing the problem.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.