Posted by NCWayne on March 17, 2014 at 14:08:57 from (173.188.169.54):
In Reply to: Straight Line posted by Bullseye on March 17, 2014 at 13:47:21:
If you want straight, and it's line of site and relatively level, you can go low tech. Get yourself a thing of mason's line and stretch it as tight as you can possibly stretch it between the two posts. You might have some slight deviation from PERFECTLY straight, but it will be just about as straight as you can get without spending the money to get someone to put up survey stakes to guide by. I did it this way when I put up a fence in front of my place years ago and it turned out pretty well. Shame of the matter was about two years later the state decided to pave the road. When they recut the ditch, etc to meet the new road they took it all down and put it back up....talk about one heck of a crooked mess.....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
