Disconnect the battery for 10 minutes to ensure that.
Remove the lower dashboard trim panel below the steering column.
Remove shift indicator cable clip (if used) and 2 nuts that hold steering column in place.
Fold it down so steering wheel lays on the seat.
Unplug electrical connector from switch.
Remove 2 nuts/bolts that attach switch to top of steering column.
Remove switch from operating rod, and install the new one.
Typically, they come with a locating pin in them that gets removed after you snug it down (with the lock cylinder in the prescribed position for switch installation).
(HOPEFULLY there's a sheet packed with the switch that details this "timing" procedure, or it'll have to be looked up in a shop manual.)
Plug in the connector, put the column and trim in place and you're done.
Shouldn't take more than a half-hour to 45 minutes for someone who hasn't done it before.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
