Posted by dej(Jed) on March 31, 2014 at 08:41:10 from (141.189.113.1):
In Reply to: welding a block posted by Brian806 on March 31, 2014 at 07:17:05:
Quoting Removed, click Modern View to see
Cast is very porous. I have welded several large pieces into blocks before. Use Ni rod, but that alone won't get the job done. What will happen is that as you weld, it will crack behind on what you have already done. I used a torch to preheat the cast to a red hot color. Next I welded several inches, stopped and cooled what I had done with water on a sponge. I next reheated the area and repeated that procedure until I had welded the whole thing. The pre heating takes the cast to near a flowing state and you then flow the Ni rod into the mix. The cooling enables the metal to stay consistent across the surface.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An AC Model M Crawler - by Anthony West. Neil Atkins is a man in his late thirties, a mild and patient character who talks fondly of his farming heritage. He farms around a hundred and fifty acres of arable land, in a village called Southam, located just outside Leamington Spa in Warwickshire. The soil is a rich dark brown and is well looked after. unlike some areas in the midlands it is also fairly flat, broken only by hedgerows and the occasional valley and brook. A copse of wildbreaking silver birch and oak trees surround the top si
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
