Usually they'll leak if the shaft itself is worn by the old seal.
If a groove forms in the shaft, a new seal won't be very effective.
If that's the case you can put a spedi-sleeve on the shaft to fix the problem.
Other than that - the shaft has to be shiny clean and free of any pitting, scratches, rust, etc.
The viscosity of the fluid you're trying to seal in plays a big role too. Any old seal/shaft will hold in 140 weight gear oil, but might leak like a sieve with engine oil. The thinner the viscosity, the more perfect the seal and surface have to be.
I hear seals can tear very easily putting them on, but I've yet to ever tear one myself even during some less than perfect installation practices.
I'd assume you're putting it on in the right direction - the lip pointing in towards the oil side.
Tap them in very gently and evenly, make sure they're not crooked.
If they're double seals, you can sometimes pack some grease between them to help seal better.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Museum Coverage: The Stuttgart Agricultural Museum - by Cindy Ladage. While cold wind was blowing back in Illinois, in Arkansas, daffodils were in bloom, and the Magnolia trees were adorned with fragrant blossoms. Stuttgart, Arkansas was the site of this year's winter Minneapolis Moline Collector's show February 25-27, 1999. The show was held at the Oliver Museum created by Don Oliver, the pioneer of the four wheel drive tractor. Oliver along with Gale Stroh and Kenneth Bull using Minneapolis Moline tractors and parts created what has become known as
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.