Posted by AlanA on May 09, 2014 at 12:10:26 from (99.101.114.214):
Bought my first narrow front tractor last month, and I have a few thoughts. Some of you have been driving them longer than I've been alive, so take this with a grain of salt. :D
I've always heard that a NF tractor was less stable/more dangerous than a WF tractor, especially running a drag-type mower.
I have had multiple friends acquaintences get hurt or killed on them, but in NOT ONE of those cases was there a roll-over. 3 different cases where the operator fell and was chopped/crushed.
I want to propose a different theory: It is not the front-end. It is the operator station. If you start to fall, there is NOTHING but the steering wheel to grab. Sitting on my 39 H, I have to hold on to the steering wheel, push in the clutch, reach WAY down backwards behind me to engage the PTO. IF I had the tractor in a drive gear and my foot slips off the clutch while performing these gymnastics, I could easily lose my grip on the wheel and then ...thump thump thump thump.
So rule 0: Never engage PTO with the transmission already in a gear. Start in neutral, engage PTO, then engage tranny.
I "growed up" running an 8N and a Fordson Dexta. One of our mowers was a wide-open drag type, and we rigged up a pipe frame and chain-link screen to protect the operator from sticks, chunks, and rocks thrown forward from that beast. It was worse than most, but pretty much any drag-type bush-hog could benefit from the use of such a screen. This would also help with the "nothing to stop your fall" issue.
There IS an issue: the WF guys have a point. But I don't think it is the NF itself.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
