Farmer, glad to hear youre seeking out help instead of letting Bubba engineer it lol Lets take this one step at a time:
WHAT YOU ALREADY HAVE
1) Under the old code a 120/240 volt Single Phase Three wire service sub panel in the garage could legally be fed (subject to a few other requirements) using ONLY 3 wires, 2 UnGrounDED Conductors and 1 GrounDED Conductor (Neutral) in which case the Neutral would be bonded to a proper GroundING Electrode such as driven rods etc. Its treated as another Separately Derived System.
2) The later code required you to run 4 wires, 2 Hots, Neutral, Equipment GroundING Conductor in which case the Ground buss and Neutral busses are kept separate and isolated.
SOUNDS LIKE YOUR UNDER THE OLD 3 WIRE CODE TO THE GARAGE
If that's so and you want to leave it as is??
Id treat the new buildings panel as a current code legal sub panel fed from the garage (its treated like a main panel in this situation). That means you run 4 wires,,,,,,,Since every buildings (if new building is separate) electrical service still requires grounding, for that sub panel its ground rod would wire to the Equipment Ground Buss. If the new building is a part of the garage or an addition???? You wouldn't need another ground rod at its sub panel.
CONSULT LOCAL AUTHORITY as what they say counts NOT me or Bubba or anyone else lol
I guess the difference is if the new bldg. is a garage addition or a new separate building as far as if a new ground rod is required. If same buildings no additional ground rod (building service already has one), but if a separate building yes you need another grounding electrode.
SORRY I HAVE TO RUN so no time for a better detailed explanation but I will check back later tonight and add to this if necessary
John T Too long retired electrical engineer and rusty on latest codes so no warranty but I will check back later
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.