jdprobman said: (quoted from post at 18:34:48 06/29/14)
Tx Jim said: (quoted from post at 18:30:48 06/29/14)...but it's far from a true WET CLUTCH that requires hyd pressure from a hyd pump for engagement.
Oh, I see. My ignorance talking there.
It is entirely possible that one and/or both cylinders were set wrong when I put them back in, and that would cause premature wear etc.
However, if the master cyl was not allowing bleed-back would the clutch have worked at all since I put it back on? I suppose it could have shifted...
Thanks for your input
Well it is possible to work the clutch pedal fast and pump fluid in the slave cylinder till it bottoms the clutch out and upon release of the pedal most of the excess of the trapped fluid can't drain back if the return orifice is blocked off leaving the clutch still disengaged.
If you have a steel braided hose in between the slave and the master it is possible that the rubber inside has come loose and works like a valve...letting fluid past but not flow back or only slowly.I WOULD CHECK THAT HOSE if it has one.
It sometimes happens with these rubber lined hoses on brakes, fuel and hydraulics as well.
This post was edited by bison at 22:24:31 06/29/14.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Purchaser Checklist - by Greg Sheppard. Pound for pound the 550 is better than anything I've seen. It has great power for its size and can really hunker down and lug. Classified as a 3-bottom plow depending on soil conditions. I personally don't think it can be beat for a utility tractor in the 40 HP range. They are extremely thrifty on fuel, at least my DSL is. Most drive train parts are fairly easy to get. Sheet metal is probably the hardest thing to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
