Posted by jimg.allentown on July 13, 2014 at 14:56:12 from (98.115.105.174):
In Reply to: Ferg uson Tractor posted by Harry Keller on July 13, 2014 at 08:50:01:
Did you check the end gaps on the rings? If they are not the right size, that will tell the story very quickly. Also, as previously stated, plastigage the bearings! While clearances give you a decent amount of leeway, if they are too loose or too tight, you will find out the hard way if they "were" right.... As for the sleeves being above the block 25 to 40 thousandths is a big spread. At that height, I would think that they might interfere with the sealing of the head gasket. That will depend on the way everything is designed to fit. Without a manual or at least access to some service information, you are only GUESSING. To the old timer that is intimately familiar with this engine, guessing is OK. To an inexperienced guy, guessing is unacceptable.
Remember: Experience is a tough teacher. It tests you first, and teaches you after.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.