Posted by NCWayne on July 16, 2014 at 19:26:00 from (173.188.169.54):
In Reply to: Close escapes posted by Bernie/MA on July 16, 2014 at 15:57:10:
Came close to getting crushed between the track frame off of a D9G and the main part of the tractor about 5 years ago. The track frame had gotten into a bind, and unknown to any of us, the excavator being used to sit the frame in place had a malfunction in one of the pilot valves and was causing the boom to lift very slowly until it had a lot of tension on the frame. When I crawled between the frame and the machine to give the bottle jack holding the hard bar a few strokes, those few strokes broke the bind and I heard a pop. I went to back stepping and was maybe 5 feet from the end of the frame when it jumped about 5 feet in the air, hit the side of the machine several times >>>>>>where my head had been about 3 seconds earlier<<<<<<<, and then set back down on the ground. We all somewhat laugh about it now due to the look on the excavator operators face, but at the time it scared the crap out of me.
There were others over the years where I could have been hurt, but this was the closest I have ever been to actually being killed.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.