OK, let's flog this one to death.... Of what I know about engines..... 1) It is a proven fact that leaner mixtures burn hotter. That is why modern engines use EGR - to COOL and DILUTE the combustion to reduce peak temperatures. This results in less formation of NOx. 2) Retarded timing will also make an engine run hotter. Just look in any old auto repair manual (like an OLD Motor's or Chilton'e). One of the listed leading causes of over heating is retarded timing followed by mixture too lean. 3) Fuel is introduced into the combustion chamber as a VAPOR, and should therefore have minimal cooling effect. 3) OCTANE! Most people do not know what octane is or what its effect is. so.... a) Octane is a comparison to what was once designated as the "ideal" motor fuel....Isooctane. b) Octane is determined by flash point and rate of burn when ignited as well as Reid vapor pressure. Lower octanes have lower flash points and faster burn. In view of this, I would say that octane most certainly DOES have an effect on run-on!
The bottom line is that you still need fuel mixture, compression, and an ignition source for an engine to run or run on. Given that the compression will be present after the engine is turned off, and that fuel mixture will also still be available, the source of ignition comes into question. Given that after the switch is turned off, the engine parts are still moving, and are still hot, I would say that my conclusions are as follows:
1) Reducing the idle setting would also reduce the likelihood of running on. 2) Higher octane fuel would also reduce running on due to the higher flash point. 3) Timing is irrelevant. 4) Reducing operating temperature should also have an effect on running on.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fordson Model N: Field Service Operations and Lubrication - by Anthony West. The daily or weekly servicing of any vehicle is of the utmost importance, and in days gone by when our favorite tractors were doing an important and Commercially vital job on the farm, these service operations would make a major difference to the running costs and economy of the farm. This being so, it surprises me to see how many enthusiasts attending rallies, shows etc, seem to be unaware of the importance of this constant attention. Possibly the modern machine with its 6,000 mile or even once
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.