Posted by Jon Hagen on July 27, 2014 at 16:52:55 from (69.26.17.61):
In Reply to: Re: Sealed Bearings posted by Mark Robke on July 27, 2014 at 16:25:25:
"I agree with the infra red thermometer-if it's hot-it's going bad! Mark "
And I will add, get a sealed bearing grease needle. They are a big hypodermic needle with a grease zerk on the end to attach to a grease gun. If a bearing gets noisy or starts to heat, work the needle between the plastic seal and inner race, metal seal bearings need a tiny hole, the size of the needle drilled so you can grease them. Then give the bearing a shot or two of Mobil 1 synthetic grease. I have extended the life of sealed bearings several 100% by doing this.
Changing the top line shaft bearings on my Farm King grain auger is a terrible job. I drilled the seals on all the original noisy bearings and gave them a shot of grease. 4-5 harvest seasons and they would start getting dry / noisy again, so the bearings got another shot of grease. Kept the original set of bearings going for 30 years that way, and their still good.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.