I have a hammer mill - don't know if there is a make/model tag on it. It was part of the old machinery collection the previous owner of the farm had left in the woods. The sheet metal is in bad shape but the rotating parts are good. I plan to use it with my 8N.
Dad had a hammer bolted to the barn floor just inside the main sliding doors. With the doors fully open the belt pulley was exposed for the belt. The 8N was backed into position on the barn hill and belted up. The tractor was alway parked in the same spot with the brakes locked, I remember the pockets in the ground from the tractor wheels.
The hammer mill was not run at PTO speed but always with the 8N at full throttle. Still remember the sound of the tractor and the noise of the hammer mill.
The hammer mill lost a hammer one day - due to the unbalance it dang near tore loose from the floor. Nearly the entire barn was shaking until dad got the whole mess shut down. The hammer mill never run again - dad would not go near it and got all the feed ground at the mill in town.
And thats my story of the hammer mill. In answer to your question a 27 HP 8N will run one.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.