Posted by GVSII on August 17, 2014 at 16:08:13 from (74.79.219.122):
In Reply to: Synthetic Oil posted by David G on August 16, 2014 at 06:36:06:
[quote="GordoSD"](quoted from post at 19:20:51 08/16/14) Years ago when I was the single test pilot for F4's at a rework facility I saw a couple of civilian workers loading up some barrels of oil. I( asked what it was and where it was going. They told me it was Mil-L 23699 USN equiv to Mobil 1. Used in the J-79 in the Phantoms,turning 23,000 rpms.
They said there was a new oil out and this was going to salvage (burn)
I said "Can you forget to load two barrels and I will dispose (burn) them for you?"
That was 110 gals and 30 years ago and I only have 45 gals left.
If you are driving by the Corn Palace, stop and get 5 qts. LOL[
Gordo,wait a sec.I'm pretty sure the J 79 turned between 9000 and 10000 RPM at mil/intermediate power.Didn't change much burner was selected.
As for the mil 23699-I know Castrol was one vender and I think Mobil and Amsoil were also bought.I also know we went through case upon case of oil.When I was still in the airforce on C130s we were still useing mil 7808 and didn't go through any where as much.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
