larrystn said: (quoted from post at 14:32:58 09/07/14) Eliminate the stroke control valve and it could certainly be used open center. The resevoir would have to be above the pump but it would work.
Larry
If stroke control valve was eliminated what will control pressure? I know for a fact I was quoted from a JD engineer about a nearly new JD 4430 under warranty that busted the rockshaft housing while lifting a rear JD 7 row flex bedder that the only limiting factor on now much pressure a JD CC piston pump could attain was the amount HP of the engine turning the pump IE unlimited pressure.
After giving this some thought I suppose a conventional hyd relief valve will work as long as the piston pump has a oil supply.
This post was edited by Tx Jim at 12:07:36 09/07/14 2 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
