What several guys around here have done is make a normal looking single spear bale carrier. Then take two pillow block bearings that will slide over the spear. Then make a flat plate about three foot in diameter with a hole in the center to go over the bale spear. They then take a large sprocket ( The one that drive the reel on a JD combine works well and the hydraulic motor is sized right for it too) mount it on a brake to the back of the plate. You put a bearing on each side of the plate. They just cut the center out of the sprocket and mounted it under the bolts that went through the pillow block bearings and the plate. So you have your turn table. Then you weld several spikes to the plate. Make a mount for your hydraulic motor to line up with the sprocket.
I know I have not described this very well but I have attached a picture of a factory built one that works the same way. They basically turn the bale around the center spear. The guys with them have used them for years without issues.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
