This is not my first rodeo I have owned my share of air tools and been suckered into buying Snap-on air tools :cry:
On the IATN web site a snapper rep admitted snapper air tools were not up to snuff :shock: That's the only thing that saved his arse from the beating he was getting from the X snapper and now IR air tool lubbers....
"Gentlemen: as a operator of these guns in the 90's, as you
speak, i can share your concern. It could be said that this
was FIFTEEN years ago. the guys that designed those have
long ago retired. it could be better for you and your
therapist to let the baggage go"
Then he goes on and recommends we give a new snapper gun a try
:roll:
"in the event the products
do or do not work for you i will only recommend you give
them a try. all reps have demo units that are available to
use. they are usually very heavily worn and abused probably
not in the best of condition. (read really thrashed)a brand
new one is a more appropriate experience of course"
So a used one may not be up to par buy a new one for an appropriate experience :?
The proof is in the pudding you will find professionals prefer IR 10 to 1 over a snapper air tool... There will always be one are two snapper die hard's in mix.... I spec that would be rational that 1 out of 10 snapper air guns performed as designed... If you are stuck on snapper air tools then you will never experience the difference...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
