Posted by Don-Wi on October 08, 2014 at 09:42:23 from (66.87.76.71):
In Reply to: drawbars posted by Mike(NEOhio) on October 07, 2014 at 19:24:23:
I welded up the drawbar from our Massey 285 when it snapped on dad hauling manure. I remade the hitch on the spreader but didn't make the pin hole big enough so when he went through a furrow the pin didn't have enough float and it snapped the drawbar.
I V'd it out almost to a point, and just started welding away. Once I was done,I put it inside a fiberglass blanket and let it cool slowly. We were cautious at first with it but it's been several years now with no signs of cracking. Dad did buy another used one, but the one that broke had a 4" drop where as the replacement had only a 2" drop. Didn't line up with any of the pto's on the equipment anymore and didn't match our other tractors so the 4" drop went back in.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
