Posted by Texasmark1 on October 11, 2014 at 06:15:54 from (172.243.93.14):
In Reply to: Re: Racoons posted by prawn farmer on October 10, 2014 at 17:03:26:
Hmmmmmmmm. Just maybe it was dogs. I thought it funny that coons would come up to the shop to get at it when the shop is a good piece from the water and there is plenty for them to eat down there. The bait was disappearing nightly and over time amounted to a fair expense. But dogs do roam at night around here and pee on my tires and get into my trash. County has an ordinance against loose dogs as it is. I keep my dog in a 40'x40' pen.
Now that I think about it there used to be a pack of dogs down the road that ran loose all the time. Lots of barking and all. Recalling events of late, don't see many lying in the road any more and the barking has all but subsided. Nobody came around asking any questions. If it killed them off, I guess they figured it was natural causes.
I didn't do it intentionally, but now that I know what I just learned, I think I'll buy it in the little protected pouches to put under my vehicles as I have only had 2 problems with my 2011 Silverado since buying new and both were wires gnawed into, not covered (obviously) by the warranty and cost me $250 to have fixed.
The rats can go and eat elsewhere or suffer the consequences.
While on the subject, I used to have a pretty good mouse problem in the house. I now go around the house throwing some under there and they have all but disappeared.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
