Posted by willie in mn on November 02, 2014 at 01:14:08 from (64.12.116.16):
In Reply to: My Pipe Rack posted by Chris Jones on November 01, 2014 at 19:23:04:
Looks good so far, but a few low cost (cheap) additions can make it better. I am not picking on you, just a few hints learned from experience. Have seen a lot of people beside the road readjusting items that have slipped out of place.
First off, any load extending 4 ft or more beyond the bumper is required to have a flag at the end.
Instead of just running the strap over the load, do a "belly wrap" completely around the bundle, then down to tie down rings. Keeps items in center of load from working their way out from vibration or a quick stop. Pull tight enough so it thumps like the string on a bass fiddle. Make the bundle as close as possible to a square or triangle to stiffen it up. O O O O O O O O O O XXXXX XXXXXXX XXXXXXX XXXXXXX If load extends forward past windshield, run a "belly wrap" to prevent flexing. For a single, or a few pieces, extend strap to wheel well. Use padded hooks to protect body paint, run strap just snug, not real tight.
For just a few sticks of pipe or lumber, a metal 5 gal bucket over the end & tied back to the rack helps hold from sliding out. Happy motoring 7 be safe. Willie
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
