Posted by Steve@Advance on November 02, 2014 at 14:01:36 from (107.203.134.67):
In Reply to: ferguson to30 posted by to30man on November 02, 2014 at 08:35:40:
Really need to identify the alternator. If there is only 1 wire on the alternator, either it is a "one wire" alternator that has internal circuitry that makes it work with only the one wire, or it is another type alternator that has had the wires pulled out or was never wired to begin with.
If it is a one wire alternator, there should be 12v to the terminal at all times. Once the engine is started, it should begin charging, up the voltage to about 14 to 15 volts. The connection "window" for the unused connections will still be there, but there won't be any terminals to connect to. This type alternator sometimes will need to be reved quite high to begin charging. Also be sure the belt is not loose or badly worn.
If it is standard alternator, depending on the brand and type there will be other connections. The most commonly used is a Delco 10SI. It will have the large output terminal, 12v all the time, and 2 other terminals, labeled 1 and 2. Terminal 1 will wire to the ignition switch through a resistor, an indicator lamp,or a diode, your choice, the indicator lamp is easiest. Terminal 2 will jump back to the output terminal.
Back to your original question, how to know if it's working... You need a volt meter to check the output. If everything is wired correctly, and it still doesn't charge, there is a problem. Most auto supplies can check them off vehicle. They are repairable if you have a volt/ohm meter. Or trade it for a rebuilt one.
This post was edited by Steve@Advance at 14:07:33 11/02/14 2 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
