Posted by nebraska cowman on November 15, 2014 at 14:09:42 from (66.252.116.102):
In Reply to: What the heck is a posted by Mike in Mn. on November 15, 2014 at 12:00:53:
The weight as mentioned was to counterbalance the vanes on the wheel. Modern windmills are governed by a spring tension on the tail which keeps the wheel pointed into the wind. In severe wind conditions the spring will allow the wheel to fold around to the tail and thus not facing the wind it will slow down and not tear itself to pieces. I have seen mills actually stop in a hard wind. The early wooden mills had a complicated system where the vanes in the open or shut to regulate speed. The weight was slid in and out on a bar to regulate the adjustment. They were not self governing and if a wind came up you had better be paying attention and either shut the mill off (by pulling (furling) the tail in so it does not run or climbing up and changing the setting on the weight. Weights were made in ornate shapes, many times animals such as a rooster or a horse, peculiar to the manufacturer and are highly sought after by collectors
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
