Posted by Janicholson on January 06, 2015 at 18:54:32 from (74.60.94.18):
In Reply to: Farmall H motor rebuild posted by 1945FarmallH on January 06, 2015 at 18:43:29:
Though controversial, there is no real way that the issue is real. Radically higher powered airplanes have had stub exhaust pipes 4 or 6 inches long and do not warp valves, or need back pressure. It is just nonsense. A open valve could have somewhat cooler air blow into it. It will however cool rather evenly as a result. Back pressure can only help an engine if the pressure pulses are timed through real research/dyno testing to hold in intake charge that would be exiting the port from supercharging or radical cam timing. Usually the header systems are designed to be a partial vacuum at the port to assist in scavenging all exhaust out. I recommend a muffler however. Because an H with a straight pipe has given me tinnitus in both ears (it is very not good) Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
