Posted by JD Seller on January 24, 2015 at 19:48:56 from (208.126.198.123):
In Reply to: Re: IH and JD tractors. posted by Bryce Frazier on January 24, 2015 at 19:28:07:
Bryce The factory hydraulic on a IH "H" and a "M" where a belly pump that is driven off the PTO shaft that passes through the pump/reservoir.
There where kits to put a hydraulic pump in between the distributor and the timing gear to have live hydraulics. The hydraulic control on the IH "H" your getting will be just a rod with a loop on the end. You pull up on it to control the hydraulic flow to a cylinder. IF I remember correctly they where single acting too. Meaning they just power up and gravity down.
You should check this out if your planning to use a wheel disk behind that IH "H".
The top picture is of a standard IH "H" look at the rod running down to a lever under the starter on the right side. That is the hydraulic control lever. There is a two valve kit that can be mounted there but it is still not "live"
The bottom picture is of a IH Super "H" with a live hydraulic kit installed on it. The Super part does not make it come with "live" hydraulics. It could have been an option by then but was not standard.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An AC Model M Crawler - by Anthony West. Neil Atkins is a man in his late thirties, a mild and patient character who talks fondly of his farming heritage. He farms around a hundred and fifty acres of arable land, in a village called Southam, located just outside Leamington Spa in Warwickshire. The soil is a rich dark brown and is well looked after. unlike some areas in the midlands it is also fairly flat, broken only by hedgerows and the occasional valley and brook. A copse of wildbreaking silver birch and oak trees surround the top si
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
