I'm in the same boat. Mine's 24x24,eight foot sidewalls and full of junk. I modified the rafters up front and raised the doorway to nine feet then put double rolling doors on it,each 8 foot wide,so it's a 16 foot door. I can get all of the non cab tractors in with the mufflers on,but the cab tractor won't go unless I let the air out of the tires. The 40x40 tool shed is in the right place for a nice shop and is high enough to get the big tractor in. I could build another toolshed and fix that old one up to what I want. Or I could add on to the front of the existing shop and make it 36 or 40x24 and make the addition higher. That was my original plan,but the more I think about what I really want,building a new shop next to the toolshed is what I really want to do,then it'll be exactly what I've been planning in my mind. Biggest trouble is,the electricity is in the old shop and I'll have to run all the way from the basement to where I want the new one. The water is right close to the new location though. I wanted a lean to on the side of the new one too,toward the road,so I can show off some of the tractors that I don't use right along. It sure is tempting to just modify the shop I have though.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
