Synthetic oil will seep past seals more than conventional oil. This could turn into an expensive problem on your terramite if it starts to cause leakage in your hydraulic cylinders. It could be a worse problem in a hydraulic system running 1500-2000 psi compared to running it in an engine at 40/psi. I have a Case 646 loader, similar machine to a Terramite. It has an oil cooler and fan in front of the engine. It calls for motor oil in the hydraulic system too, but it was built before synthetic oil became commonly available. I think you should stick with conventional oil in the factory recommended viscosity. If your machine has an oil cooler, it is not working properly. Some oil coolers have a filter on the inlet, the filters can become clogged and cause overheating. If you don't have an oil cooler installed, you can probably find a good useable one at a junkyard or eBay. A fan is necessary too. Hope you can get this problem solved.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.