Posted by qwertyell on February 07, 2015 at 21:53:36 from (198.58.63.252):
In Reply to: today's funny posted by jon f mn on February 07, 2015 at 05:52:55:
They say in humor timing is everything. Well,today's funny was very timely. This evening I was out in my pasture cutting down some trees on my pond dam. The sun had gone below the horizon when I drove my tractor thru the gate into my yard. Normally I always get off the tractor and close the gate immediately after going thru the gate. Tonight I drove the tractor the 150 feet into the shed I keep it in without shutting the gate...... thinking I MUST not forget to go back and shut the gate after I get the tractor put up (or the cattle could just walk out to freedom). Well, as I drove the tractor in the shed one of our cats ran right in front of me into the shed. As I lock it up every night I needed to get the cat out first. Tonight the cat played hard to get and after trying to call it out for a while I just locked the door and left her in the shed, turned and came to the house, outside chores done. Then as I was reading the day's funny it hit me, "I didn't shut that gate!" It's 11:00 PM and I'm putting my shoes on and hoping the cows have not found the open gate. Will not know until morning if they're in the pasture now...... but really think they are. So, Thanks for the timely funny. Ole memory just ain't what it used to be!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
