Posted by sms on February 17, 2015 at 04:03:07 from (24.161.115.45):
In Reply to: Re: studebaker posted by Larry@stinescorner on February 16, 2015 at 16:17:52:
Your link didn't work so looked on my own and came up with this. It was blue with solid sideboards and sometimes we would stand up pieces of slabwood to make sideboards higher. All the wood was cut to length, I think he $25 a load, really just wanted to get rid of it. The transmission shifter was worn and it would get stuck in 2nd and reverse at the same time!!! You would have to unscrew shifter fell around with it, get in proper place to slide one of the rails back to neutral then put it back in the right place for the other gear. It had the flathead 6 with a four speed and two speed rear. He also had log bunks he could bolt on to haul logs but only did that if the 6x6 was broken down. Here's a picture of the first 6x6 he used for a log truck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
