huh, why in the world would you pull a head without a compression check???, standard procedure on any engine. sure you can change all that stuff but without the points and timing set correctly and firing order correct you can have a HORRIBLE miss, as the spec's must be followed and you did not conferm that this is done. you did not even say if it ran like this before the parts replacement. we have very little info here. not even the compression #'s for each cyl. and also on a complete tune up valve adjustment should be done. as the valve seats wear the clearance between rocker and valve stem is decreased causing the valve not to close fully and then result in a burnt valve. with dist in correct position # 1 cyl. is at two oclock position then 3 4 2 to follow. clockwise. when properly timed the little point screw with the wire going to the coil on the side will be sitting right at 3 oclock position. that's correct dist location right from factory.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
Latest Ad:
1953 Ford Jubilee Tractor. Last driven 5 yrs ago. Parked ever since. As is as seen
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.