Posted by Leroy on March 23, 2015 at 15:22:46 from (69.88.205.69):
In Reply to: Hay Wagon Bed Design posted by Bill VA on March 23, 2015 at 09:28:08:
Factory built were toung and grove southern yellow pine not treated and plained to 3/4" thickness and a lot of then used 2 x 4 cross members. Remember they were for both hay and small grain-ear corn. Not sure what the sills were, my books might tell. A lot of homemade beds were cotton wood and as long as it did not touch the ground it did not rot. and was the lightest weight wood avaible with the strength needed. Don't know how it would be now with the oak but years ago if the bed was made of that you could not give the wagon away due to the weight and the heavy bedds were called horse killers as it would take 4 head to pull the wagon instead of 2 on a lighter bed just due to the weight. The factory built with the floor crosswise used 1 1/2" material and they had a steel edging along the sides to give strength to the outer ends of the crosswise boards. You should have about 6" of bed in front of front wheels and 18-24" behind the rear wheels depending on length of bed. I am talking factory built beds from 1960 and earlier and I am a 1943 model.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.