Posted by jdemaris on April 03, 2015 at 08:31:02 from (70.209.139.212):
Yeah, I know, NOT a tractor. Well, I bought this d*mn van as part of a trip that involves getting rid of MANY old tractors - so it is loosely connected.
Here's my story and problem. I now live in northern Michigan but had to come back to central NY April 1st. Got to spend a month here cleaning out my property that is selling on May 1. In Michigan - I could not find a van to rent one-way like I did another time. So I bought a van with intent to drive it one-way, and then sell it here in NY. I found a 1994 Dodge B250 van with a 3.9 V6 that was just driven to MI from Texas. 135K miles and NO rust anywhere. Paid $650 for it. I put new brakes and tires into it and drove it to NY. ZERO problems. After driving 800 miles pretty much non-stop except for gas - got to my place and parked in the driveway. Well, actually had to spend an hour first digging snow by hand to get in. Anyway, parked the van. Next morning - started it up, and tried to back out and up probably the steepest hill this van has ever been on with the rear being the high part. It suddenly died -just like I had shut the key off. No sputter, no gradual loss of power - just DEAD. Being on the hill, I was able to roll back down onto a flat parking spot. Once on the flat - I started right up but was obviously a bit flooded with gas. That tells me when it had died - it was lack of ignition. I cranked for awhile and the TBI sent a lot of gas into the engine. So here I am, kind of stumped. I know nothing about this van and have no manual. Not sure where to even start trying to diagnose something like this - especially now that it runs. Anybody got any ideas? I can't imagine how a steep hill could effect spark unless it is sheer coincidence.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
