Posted by flembo on April 14, 2015 at 12:39:29 from (69.95.213.9):
In Reply to: Adirondack Case Guy posted by Mark W. on April 14, 2015 at 10:48:26:
When my kids were growing up we tapped about 30 trees we had some real sap buckets that a friend lent me and a few 5 gallon pails along with anything else we could find. cement blocks worked as an arch and I asked a tinnocker at work to make me a pan 18" x 20" there abouts with 3" sides. A few new trash cans worked well to store sap until the weekends and if it ran well we would boil at night during the week also. If we were lucky we would get about 1 quart or so each boil and then Finnish in the house where we had better control but we also had a log cabin with no wall paper and cathedral ceilings so the steam was no problem be careful of that or swmbo will let you here about it. the kids had a great time. Have a fun time it is also at a time of the year when your ready to get outside. Good luck.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
