Well I am home. Got the area he wanted done, big part of the job was to clear out roots from some type of brush that was in some of the areas....very tough roots. I can rip out 6" pine stumps easier than some of these. Anyway, typical, I get there, gate is locked, nobody answers the phone. I lay on the horn twice in 10 minutes then the wife finally comes out and says they overslept...I was 2 minutes away from leaving. So, everything goes good from there on...get signed in, get my ID badge...dirt turns out to be pretty soft so I do get down 20-24". Dusty and dirty work. This is a retired Californian, obvious long time grower, so I didn't try to tell him 24" was not necessary. So they are happy, said it was the first contractor that did what he said he would do....also want me back to do the rest and pop out some holes with the 2' auger. I did get paid :D
Went over to my mowing job looking to put in 4 hours there, but I had a front tire go flat at 2 1/2 hrs...and the spare in the truck was flat! Oh well, short day, only 12 1/2 hours....
Thanks for all the comments...I was sure this would have been poofed by the time I got home.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.