Posted by notjustair on May 19, 2015 at 19:36:34 from (70.195.2.136):
In Reply to: Control arm on 8N posted by gmoose on May 19, 2015 at 19:26:56:
The arm that goes from the top cover inside the unit (to the pump)? Yes, it should be straight. Everyone will tell you to bend it straight. Let me share a story.
Mine was in a very pretty arc. I couldn't have made a better bow in it if I tried. It bowed out in the middle a good two inches. I layed it down on the machine shed floor (bow side up) and tapped it with a hammer until it was straight. Like, just nice taps - the rod isn't a thick thing. I decided it needed one more tap. I hit it one last time and the ball end that fits into the pump broke off and shot across the machine shed. It was like something out of the three stooges.
I welded it and ground it back down, but the mental torture was too great. I got a used replacement and kept the welded one as a backup. Be careful when you bend it.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
