Posted by Texasmark1 on May 26, 2015 at 05:04:24 from (172.242.2.247):
In Reply to: Re: Yard Light ? posted by Texasmark1 on May 26, 2015 at 04:56:23:
I had several Mercury vapor (besides the ones the power co put up) and when they crapped out, I replaced them with 65w fluorescent which illuminated ok but failed prematurely. So as they died off, I took the 65w fixtures and removed the large socket and replaced with a regular household size, naked socket and screwed in a 100w 6500k bulb and wired it to run 24/7 so I had nothing else to break and it stayed at max brilliance....didn't have to warm up. At 26 watts vs 175 I can leave them on and make money plus they do better staying on. Light isn't as bright but plenty adequate for general area lighting and didn't have to buy another expensive fixture or light sensor. I'm getting a bit senior to be climbing light poles.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
