Posted by middlemiss on May 30, 2015 at 12:25:38 from (38.80.64.20):
New to the forum - need some advice. I have a line on an old Ford 600 series tractor with a Dearborn loader and what looks to be a Sherman Power digger backhoe attached. The tractor itself looks decent and is equipped with the 3ph and pto. I am not sure of its specific 6series number.
There are a few issues with the tractor, might need a rear tire and the rear end is apparently broken, from what I am told the rear end broke internally while the old owner was using the backhoe. It doesn't drive. I looked around for parts and I can buy a complete rear end for this tractor but it seems pricey. are parts from a 8n,2n or 9n compatible? Has anyone had an experience with this kinda issue?
I would go and see this tractor first hand but it is a couple hours away from me and I just cannot justify the time to go see it unless I am committed to buying it.
I will post pictures asap. I appreciate your comments and advice.
Thanks
This post was edited by middlemiss at 12:39:39 05/30/15.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
