I think you're look you're looking at it backwards. What is it you need to accomplish? Then you can decide the most cost effective way to do it.
Your building site has three requirements: Good drainage, good approaches to the entrances and a reasonably level, compacted base on which to pour the floor. You have to solve the first two problems first! If you have a very large lot to work with, it's not that difficult to cut from one area and fill to another. But if you have a small lot or need to build close to a property line, you may have no choice but to bring in fill to get the site you need.
Getting the fill compacted can be a problem if your fill dirt is clay or has a lot of debris in it (e.g. topsoil). But you should be OK if the fill dirt is clean and sandy. If you have a reasonably heavy tractor, it will compact reasonably well when you grade it out. For a really solid base, consider bringing in some crushed limestone and packing it down.
If you're going to add several feet of fill, you need to be concerned about what your posts are sitting on. Ideally, the concrete plugs at the bottom of the post holes should be sitting on undisturbed soil. As long as you don't fill more than four feet that shouldn't be a problem. If you fill more than that, you need to be sure the fill is well-compacted at its base.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.