Posted by Ron in Nebr on June 25, 2015 at 18:50:25 from (199.47.65.59):
In Reply to: Antique hay rakes posted by WIZZO on June 25, 2015 at 05:51:33:
Don't recognize that model, but the one in Pair-A-Dice Farm's pic below is an IHC rake dump rake. The folks here in the Nebraska Sandhills who still stack hay rather than bale it still use similar rakes, but they can be up to 46 foot long and hydraulically dumped. The older horsedrawn versions were mechanically dumped- a foot pedal or lever was pressed(or pulled) and cogs in the wheel hubs would lift the teeth to dump the hay. It was and is an art to make straight windrows using these.
I pulled a 46 foot dump rake behind a super H farmall when I was 10 years old. I raked all our meadows after the bar-mowed hay had dried. Put it into windrows that the sweeps would push to the stacker. Some outfits ran two similar rakes- a "straight rake" that did the initial raking, and a "scatter rake", that went behind and picked up anything left over and put it in windrows. Other places, like ours, used the same rake for both purposes.
Initially, these were pulled by one or two horses, with the operator sitting on the seat. As tractors came into use, it was common around here to see an F-20 fitted up with 3 twelve-foot rakes- one directly behind and two on either side on homebuilt "outriggers". That was normal until the late 50's when the custom-built larger hydraulic rakes started to show up. A popular brand here in Nebraska was a "Valley" rake....36 foot wide, and the two outer sections would fold up hydraulically to go through gates, etc.
We round bale now, but still keep a 36 foot dump rake around, and use it occasionally to pull hay out of low ground after rainstorms.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
