I'm a machinist so I have the tools and ability to take precise measurements. That being said, the flow control valve spool looks good having no flats worn on it and the bore/spool clearance measures only .003-.004 clearance. When I bought the tractor about 6 years ago I had the control valve spool out due trying to get to the bottom of just the opposite as now. At that time, I had good power steering but no pressure on the rear remotes. This was the first time I ever tried using the remotes. Upon flow control valve spool removal, I noticed the orifice in the flow control valve spool had been drilled way open(5/16") by a previous owner. I presume to improve power steering since it was a loader tractor much of it's life. Due to the huge orifice I don't think the flow control valve spool ever shuttled backing and forth causing wear. I think so much oil could pass through the over sized hole the spool was motionless many years causing no wear to it or the bore. So at that time, I tig welded the oversized orifice shut and drilled it out to first 3/32" then to and 1/8" to achieve some flow balance between decent pressure on my rear remotes and the power steering. This fix worked well and did so 'til last summer when my power steering started to deteriorate. Since then it's been process of elimination to conquer this problem. Any more thoughts? I appreciate the input.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.