Posted by FBH44 on July 17, 2015 at 02:13:19 from (64.85.216.58):
In Reply to: Farmall m clutch posted by rkbenish on July 16, 2015 at 18:08:17:
There's three small bolts with lock-nuts that maintain a 3/16" gap between the ends of the pressure plate fingers and the throwout bearing. THere's one little bolt / lock-nut on each finger. The gap is measured to be 3/16" with the clutch pedal resting all the way back against the transmission cover plate. Make yourself a small 3/16" wide tool of some sort, that you can stick up there to mesure the gap. I use a piece of copper electrical ground wire, happpens to be 3/16" wide. [ If I m describing this understandably. ] You rotate the engine / clutch by hand with a crank three times to get to the bolts from below. Don't know about the M, but on the H the pressure plate finger gap can be adjusted very easily, from below, once you remove the small access cover plate. Might be it could be accessed very simply on the M too. When I adjusted my H, it made all the difference. Then you adjust that clutch rod length to leave a gap of 1 1/4" or so, 1 1/8" someting like that, between clutch pedal arm and tranny cover plate, with mere finger pressure pressing the pedal forward. Hope this makes sense, hope I am describing this helpful. Hope I'm correct for the M.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
