Posted by Bryce Frazier on September 21, 2015 at 17:13:44 from (67.142.182.26):
Went to go look at that other Farmall M today...
Has a nice DuAll 250 loader on it, with a 3 spool valve, and remotes at the bucket. Wide Front, tight steering, nice machine all in all.
The Bad,
No sheet metal, Left Brake issues, Clutch is tight, Engine is stuck ( I think ) Front bolster is wasted, Frame rails are bad ish wfe needs tie rods and rims to be serviceable.
The Good,
has 15.5 x 38 rear tires, at probably %75 tread. Has a LIVE Mag Drive hydro pump for the loader, and a different Mag attached to it. Has an "EZ" ride Monre seat, minus the shock. 2 sets of rear wheel weights. Unbroken rear wheels Nearly all of the throttle linkage, and that kind of stuff is TIGHT.
And quite possibily the biggest plus of all, it has an X1 at the end of the serial number... Which, if it is the same as the H, means that it has the higher compression head / engine right?
Very excited about it! No pictures yet, but I hope to get it home soon...
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
