In my career we always applied ant-seize to all fasteners on the WESTINGHOUSE STEAM TURBINES and WESTINNGHOUSE W92 Gas Turbine fasteners on the "Case Split Lines". These fasteners ran greater than 1500 deg F. Also the HEAD BOLTS on the 4000 HP NORDEBERG,2000 HP & 4000 HP Ingersoll Rand, as well as the 9000 HP Clark/Dresser Rand units. All HEADBOLTS,STUDDS and NUTS that required a Specific TORQUE were lubed with ANTI SIZE. Most all head bolts were torqued to 100FT LBS and then a HYDRAULIC JACK was attached to the THTREADS protruding through the NUT. The HEAD STUDDS were then stretched until all JACKS/RAMS read 10,000 PSI . At that point all NUTS were ran down until they came in contact with the head or the machined BOSS on the head. There was a Girdle that held as many RAMS as there were HEAD BOLTS so as all STUDDS were stretched the same amount at the same time. Bob...
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
