Draft control uses the amount of pulling force and "suction" of the plow in the ground to control the depth of the plow in the ground. The early 400 had a second cylinder on the front of the hitch attachment point, under the transmission. This cylinder could be used to tilt the fast hitch (over quite a range) and was a fair attempt at a manually controlled (seat of the pants) system. (I like it best of all the 400/450 series hitches. Later 400 and 450 tractors had a draft control with a "D" handle on the left side of the platform that was a next generation fixed amount draft control. It worked OK but was not as sensitive as an internal hydraulic draft control. It worked OK on Farmalls, not so much on Utility style. There is no chance of flipping over backwards with a fast hitch plow because the plow cannot go past its full up position. it could do a wheelie, but not flip. Draft control does not work on trailer type plows on any tractor. Flipping over backwards is very unusual and takes real wrong procedure to do if hooked to a standard drawbar. If hooked to a fast hitch loop drawbar, or 3 point drawbar, in the full up position, a tractor could flip. Jim
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.