Had a couple uncles that shouldn't have survived - one rolled an 8n brush hogging and broke his back; another had his clothes ripped off on a pto shaft, got away with just a broken arm.
Myself? Nothing major, yet. It's tough to remember all the minor things, but here's a few: - the widowmakers dropping standing dead trees that "just missed" (one 8' length of limb just 4 days ago - it's getting so I spend a lot of time looking up, before, during and after a cut); the time I laid open my right thigh pulling the knife from a 9' NH haybine; the 4" gash in the other leg when I slipped off a baler tire in a packed machine shed and ripped it open on a bolt (both should have had stitches, but got butterflies instead); getting beat up sorting calves just in off pasture in the autumn; kicked / stepped on by horses and cows; getting laid out on my butt or back smacking my head in a low clearance barn (at least 4 times - love/hate those ball cap brims); the dung fork I put through my boot, right between my toes; the wood chip splitting wood with a maul that hit me in the left eye (went to the ER for that); the wagon tongue that fell off the tractor drawbar and landed on the arch of my foot (ER for that too - nothing broke, but it was over a week before I was walking good again); etc, etc. In the close but no cigar category: the Allis WC bringing a trailer load of fire wood down a hill with wet fall leaves that took a 100' slide before catching a tree with the right rear that nearly threw me off...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
